DAT3060-IS Negative Pressure Isolation Shelter
10'' W x 20'' L x 9'' H - Shelter only with double door 'airlock', full velcro closure air vents, clear vinyl windows, HVAC air ducts with tie closures, fully zippered connector flaps on each end to attach one unit to another; use with the F-MAP cold plasma ionization filtration system or the #F-HAS HEPA air cleaner.
General Specifications For All FSI Shelters:
Air pressure internally once inflated = 4.3 psi (0.3 bar)
USA Federal Standard FS # 191 5041/5102/5134/5970 Test method structural test results
- Total Weight (g/m2) – 1055
- Thickness (mm) – 0.90
-
Cut strip tensile strength (lbs. /in.) – Warp = 450 - Weft = 404
-
Elongation (%) – Warp = 30 - Weft = 47
-
Tongue tear (lbs.) – Warp = 87 – Weft = 100
-
Adhesion (lbs. /in.) – Warp = 9.4 – Weft = 8.9
-
Density = 30 X 24.5
Frame: Heavy duty 1100 dtex polyester coated w. plastomer on both sides, UV/chemical resistant. Cover: Heavy duty 420 denier nylon coated w. polyurethane (PVC) on both sides. UV/chemical resistant/fire retardant. Floor: PVC coated .52 mm polyester.
Standard color is ‘EMS’ Blue exterior w. high visibility white inside color. Green and White exterior canopy color also available at no extra cost. Other colors optional with an extra charge.
All Shelters have full privacy zipper closure and full screen zipper closure slip in and out dirty entry/clean exit doors, air inflation valve, one air inflation hose w. safety cord, pressure relief valve, tie down ropes and 4 D-rings to tie off to, repair kit, manual, carry bag, 2 upper air vents, and a hammer. All canopy walls are velcro’d to the floor air berms for air lock, and reflective striping is found on the upper air vents above doors and on entry and exit integral shower stall air berms. Units can attach to a second shower or FSI shelter. Simply inflate the unit and commence use in approx. 1 - 4 minutes (size of shelter dependent).
Every FSI DAT™ series shelter comes complete with electric inflator/deflator, and high pressure scba fitting.
