SAFETYRAIL 2000

Meet the World's Most Versatile and Non-Penetrating Guardrail System!

Companies are using SafetyRail 2000 for:

Fall Protection Temporary Fall Protection Roof Edge Protection Roof Hatches Skylights Hazard Barriers Warehouse Dock Doors Warehouse Traffic Lanes Cell Workstations Construction Dig Sites Dock Platforms New Building Construction Drive-In Truck Pits Rail Car Platforms Mezzanines Break Areas Assembly Areas Conveyors

Why Are More Companies Choosing SafetyRail 2000?

No holes need to be drilled It's 100% portable Meets and Exceeds OSHA Regulations for Fall Protection Install over 600 feet in an hour with three men Rails can be positioned in infinite directions Each base can support up to 4 rails Gate assemblies available Optional toe board brackets All rail sections have a powder coat finish Special orders for non-standard colors and galvanizing Custom engineering / manufacturing for special requirements Protect your employees and visitors with out hassle

SafetyRail 2000 has been tested by a nationally known engineering firm and found to be in accordance with OSHA regulations. These regulations are in fall protection for guardrail; sections 1910.23 and sections 1926.500 - 1926.503.

In order for SafetyRail 2000 to meet OSHA compliance for fall protection, you must use outriggers (returns/ counter weights). Whether the Danger Side Run is 5' or 1000' in length, you must have these in place at the beginning and at the end of the run. Outriggers are standard rail kits that are connected at approximately 90 degrees to the Danger Side Run of each end rail section.

Click on the diagram below for more information.

If you would like further information on the SafetyRail 2000 or would like to speak to someone about a quote, please call us at 888.972.3389.